Large Wall-Mount Display Case for LEGO Minifigures

The display is beautiful once built, but it’s a little tedious to get there. Perhaps that just comes with the territory of building a minifig display. The instructions should improve regarding the silver corner pieces with the 3 holes in them. I didn’t realize you’d need a hole to screw the final clear piece in at the end. I also just don’t understand how to mount this to the wall. The screws provided are too large to fit through any hole in the back of the display. Some color here would help a lot!!

Only negative is product came in missing 2 of the aluminum blocks to bolt it all together. Luckily i have a machine shop so i just made 2 of them to complete the assembly.

It looks amazing in the wall, but it was difficult to put together.
Two of the pieces did not align and I had to shave down a piece to try to make it fit together. The individual pegs instead of double pegs for the minifigs to pop onto were difficult to install and many required the use of pliers to pop them in.

Looks amazing

The good: Fantastic case looks, decent build quality, superb acrylic clarity, and overall reasonable added value.

The bad: Instructions can be better; clearer call outs for screw joint orientation depending on specific corner. Do not rely on the pad printed logo to orient.

The ugly: Pay attention! The bore holes on each shelf strip should be installed in the same direction as the die cutter (downwards). It's far easier to install the included Lego pebble-attachments (top-down) if the shelves are installed following the same direction as the cutter (top down). Hope that makes sense.