This display looks great! The tolerances of the slots and tabs that connect the shelves and sides of the display to the back panel are really tight, and so the display is very stable when assembled. That said, the tolerances are SO tight that it was quite difficult to fit some of those tabs on the shelves and sides into the slots that were cut for them in the backing panel, to the point where the edge of the panel broke off at those slots when trying to push the shelf tabs in. Since these slots are very close to the edge of the panel (about a half-inch) they create some of the weakest points in the panel and were quite prone to breaking when I assembled the display. It would be great if the slots that are near the edge did not fit quite as tightly as those that are further from the edge of the material, and were therefore not as likely to break during assembly. While frustrating, however, those points that did break were easily repaired with glue and did not do much harm to the appearance of the display (see top two photos). The hardware that is supplied to fasten the corners of the display together is really top-notch in appearance and functionality (see bottom two photos), and the hairline border that is etched on each panel is a beautiful touch. I would like to have given this five stars, but the breakage issues I encountered on assembly were too much to overlook. But I will definitely buy from Brickcessories again!

There were a few small cracks in some of the clear pieces, though luckily they are in spots that aren't noticeable unless looking at the display from the bottom, and assembly was easy and straightforward, just wish the "covering" on the acrylic pieces was a little easier to remove

I am very satisfied with this wall-mount display! It looks amazing fully-loaded, and it handles the weight of the sets nicely. It is far less expensive than alternative options from other companies and, as always, the customer service by Brickcessories has been first-class!

Definitely will need to glue it together, would be nice if it had more screws and blocks to hold it together. I would like to see a bit thicker shelves as well. They currently sag a little bit